Apex Digital Digi Combo - Page 29

26
4. Lock the parameter: After the doctor finish setting the prescription parameters, the
doctor can lock the parameters to prevent a patient from altering the settings. When
the doctor finish the prescription parameters, turn off the unit. Then enter the doctor
mode ( refer to step 1) first. And press the ‘MODE’ key first, then press the lock key. Thus, the
lock symbol will display on the LCD. It is OK, then you can turn off the unit. The next one
normally turn on the unit, all the parameters already been locked (the lock symbol show on the
LCD). The patient can only adjust the amplitude knobs for his comfortable intensity.
 *lockkey:‘Width▲’forTENS/Combo;‘SET’forEMS;‘Rate▲’forIF/HV
5. Unlock the parameter: When the doctor want to change the prescription parameters
which had been locked, you must to unlock it first. The follow steps are to unlock the
parameters:
Enter the doctor mode. Press the ‘MODE’ key first, then press the unlock key. Thus, the lock
symbol will disappear. It is ok for unlock function. Turn off the unit, next
time normally turn on the unit, you can re-adjust all the parameters again.
 *unlockkey:‘Width▼’forTENS/Combo;‘ENT’forEMS;‘Rate▲’forIF/HV
6. Exit the doctor mode: Turn off the unit, it will leave the doctor mode.
7. User mode: Normally turn on the unit (without hold on any key), then you are on the user mode.