iCH Auto/English 16
2. Remove the air tubing and headgear straps from the mask.
3. Wash the mask system according to the instructions supplied with it.
4. Wash the air tubing in warm water using mild detergent. Rinse thoroughly, hang and allow to
dry.
5. Before next use, assemble the mask and headgear according to the mask user instructions.
6. All items of the mask and air tubing are subject to normal wear and tear and may eventually
be
replaced. Replace the mask and the air tubing if they are damaged.
CAUTION: Do not use bleach, chlorine-, alcohol-, or aromatic-based (including all scented oils),
moisturizing or antibacterial soaps to clean the cushion, mask or air tubing. These solutions
may cause hardening and reduce the life of the product.
CAUTION: Do not wash or dry the mask or air tubing at a temperature above 70°C
(158°F)
WARNING: Do not use any cleaner containing fragrance or conditioners as they will leave a
residue.
WARNING: The mask must not be re-used by another person. This is to avoid the risk of
cross-infection.
5.3 Air Filter
For an optimum operation of the device, the air filter can be cleaned by the user at least once
every two weeks or more often if this device is operated in a dusty environment. It is
recommended that the filter be replaced with a new one after 6 months of use; however,
depending on the air quality, the replacement time may vary.
N
OTE: Please follow national requirements to dispose of the unit
properly.
5.4 Water Chamber
1. Turn the heater off and allow the heater and water to cool.
2. Disconnect the flexible tubing from the water chamber. Place thumb on the top of the water
chamber and lift it to separate it from the system. Open the chamber and empty the
remaining water.
CAUTION: Dirty air filter may cause high operating temperatures
that affect device performance. Ensure the air filter is
cleaned and fitted at all times
1. Remove the dirty filter from the enclosure on the rear of the device.
2. Wash the filter in warm water with a mild detergent, and rinse with
water. Allow the filter to air dry completely before reinstalling. Do not
use a filter that is not completely dry. If the filter is torn, replace it.
3. Reinstall the filter.
To Next Page