Apex Digital Intelli-X2 26 - Technical Specifications

33
Technical specications
Electrical specifications
Balanced line level input
Connectors 3-pin XLR (software switch-able between analog and AES-3)
Type electronically balanced
Impedance >10 k ohms, balanced
Common mode rejection >90 dB
Max input level 18, 21, 24 or 27 dBu software selectable, balanced, 1% THD+N
Frequency response 20 Hz - 20 kHz, ±0,5 dB
THD+N less than 0,005%, +4 dBu, 20 Hz- 20 kHz, 22 kHz BW
Dynamic range 120 dB, 20 Hz to 20 kHz, un-weighted at +21 dBu headroom settings
Crosstalk >90 dB
AD conversion 24-bit, sigma-delta
Balanced line level outputs
Connector: 3-pin XLR (software switch-able between analog and AES-3)
Type electronically balanced
Impedance <50 ohms, balanced
Max output level 15, 18, 21, 24 dBu software selectable, into 600 ohms,
balanced, 1% THD+N
Frequency response 20 Hz - 20 kHz, ±0,5 dB
THD+N less than 0,005%, +4 dBu, 20 Hz- 20 kHz, 22 kHz BW
Dynamic range: 120 dB, 20 Hz to 20 kHz, un-weighted at +21 dBu headroom settings
Crosstalk: >90 dB
DA conversion resolution: 24-bit
AES-3 inputs
Connector 3-pin XLR (software switch-able between analog and AES-3)
Type transformer isolated
Impedance 110 ohms or 75 ohms selectable (internal jumper), balanced
Supported formats AES-3 and SPDIF up to 24-bit
Supported sample rates 32 to 192 kHz
AES-3 outputs
Connector 3-pin XLR (software switch-able between analog and AES-3)
Type transformer isolated
Impedance 110 ohms or 75 ohms selectable (internal jumper), balanced
Word-clock input
Connector: BNC
Termination: 75 ohms switch-able
Input level: 1 to 10 Vpp
Word clock output
Connector BNC
Impedance 75 ohms
Output level TTL 5 Vpp