Apex Digital Intelli-X2 26 - Page 34

34
DSP specifications
Digital processing
Sample rate: 44,1 kHz, 48 kHz, 88,2 kHz, 96 kHz, 176,4 kHz or 192 kHz selectable
Internal processing: 32-bit oating point
Input / output channel: Intelli-X² 26: 2 in x 6 out
Intelli-X² 48: 4 in x 8 out
Network remote control
Built-in Ethernet switch IEEE 802.3 10Base-T/100 Base-TX
Connectors 3 x Neutrik EtherCon, Auto MDI-MDIX
Protocol Proprietary UDP/IP based, SNMP
RS-232
Connector D-sub 9-pin female
Mains
Connector: Neutrik PowerCon
Voltage: Auto-detect 100-240 Vac (+/- 10%) – 50-60 Hz
Power consumption: Intelli-X² 26 < 60 VA
Intelli-X² 48 < 60 VA
Input channels functions
Gain -80 to +15 dB, 0,1 dB steps
Polarity normal / inverted
Delay
Duration 0 to 1500 ms, sample rate depend steps,
Distance 0 to 500 m
Temperature -20 to 50 °C (-4 to 122 °F), 0,1° steps
Relative humidity 0 to 100%, 0,1% steps
(Temperature and relative humidity are common to all delays)
GEQ 30-band ISO centred, +/-15 dB,
proportional-Q or constant-Q mode selectable
PEQ
Bands 12
Filter types Bell-Symmetrical, Bell-Asymmetrical, Notch, Low-Shelving 6dB/oct,
Low-Shelving 12 dB/oct, High-Shelving 6 dB/oct ,
High-Shelving 12 dB/oct, All-Pass 90°, All-Pass 180°,
High-Pass 6 dB/oct, High-Pass 12 dB/oct, High-Pass Vari-Q 12 dB/oct,
Low-Pass 6 dB/oct, Low-Pass 12 dB/oct, Low-Pass Vari-Q 12 dB/oct,
Band-Pass
Frequency 10 Hz to 22 kHz, 0,1 Hz steps
Gain -40 to +15 dB, 0,1 dB steps (when applicable)
Q 0,1 to 48, 0,01steps (when applicable)