35
Compressor
Threshold -80 to 0 dBfs, 0,1 dB steps
Ratio 1:1 to 20:1, 0,1 steps
Knee hard or soft
Attack time 0,5 to 100 ms, 0,1 ms steps
Release time 5 to 5000 ms, 0,1 ms steps
Side-chain mode at, high-pass or band-pass mode
Make-up gain 0 to +10 dB, 0,1 dB steps
Mix matrix functions
Gain -80 to +15 dB, 0,1 dB steps
Routing enabled/disabled
Output channels functions
Delay
Duration 0 to 1500 ms, sample rate depend steps,
Distance 0 to 500 m
Temperature -20 to 50 °C (-4 to 122 °F), 0,1° steps
Relative humidity 0 to 100%, 0,1% steps
(Temperature and relative humidity are common to all delays)
Driver alignment
Duration 0 to 30 ms, sample rate depend steps,
Distance 0 to 1029 cm, 0,1 cm steps
(temperature and relative humidity independent)
PEQ
Bands 12
Filter types Bell-Symmetrical, Bell-Asymmetrical, Notch, Low-Shelving 6 dB/oct,
Low-Shelving 12 dB/oct, High-Shelving 6 dB/oct ,
High-Shelving 12 dB/oct, All-Pass 90°, All-Pass 180°,
High-Pass 6 dB/oct, High-Pass 12 dB/oct, High-Pass Vari-Q 12 dB/oct,
Low-Pass 6 dB/oct, Low-Pass 12 dB/oct, Low-Pass Vari-Q 12 dB/oct,
Band-Pass
Frequency 10 Hz to 22 kHz, 0,1 Hz steps
Gain -40 to +15 dB, 0,1 dB steps (when applicable)
Q 0,1 to 48, 0,01 steps (when applicable)
High-pass and low-pass crossover
Filter types Butterworth 6 to 48 dB/octave, 6 dB steps
Linkwitz-Riley 12 to 48 dB/octave, 12 dB steps
Bessel 12 to 48 dB/octave, 6 dB steps
Frequency 10 Hz to 20 kHz, 0,1 Hz steps
FIR lters
At 48 kHz: 5 x 1024 taps or 8 x 512 taps
At 96 kHz: 3 x 1024 taps or 8 x 512 taps
Gain -80 to +15 dB, 0,1 dB steps
Polarity normal / inverted
Limiter
Type Dual-stage, RMS + Peak limiter
RMS threshold -80 to 0 dBfs (or dBu equivalent), 0,1 dB steps
Peak threshold -80 to 0 dBfs (or dBu equivalent), 0,1 dB steps
RMS attack 0,1 to 100 ms, 0,1 ms steps
Peak attack 0 ms
Release 5 to 5000 ms, 0,1 ms steps
To Next Page
Loading...