(5) Low Pressure Auto Off
Press "MENU" button to select [LOW P on/off] menu, you can view if the Low Pressure
Auto Off setting is enabled and the device will be automatically turned off while detecting a
large leak for 3 minutes. This setting is adjustable only by the provider, a respiratory
therapist or physician.
(6) Compliance Meter
Press "MENU" button to select the [CM XXXX.X hr] menu. The compliance meter records
the total therapy hours for the device. The compliance meter should be re-set only by the
provider, a respiratory therapist or by a doctor.
(7) Alarm
Press "MENU" button to select the [Alarm on/off] menu, and press "UP" or "DOWN"
button to set the alarm on or off. When the alarm is turned on, the audible alarm will activate
with warning messages shown on the LCD display. Set alarm off to mute the audible alarm.
(8) Clock Alarm
Press "MENU" button to select the [Clock Alarm on/off] menu and press "UP" or "DOWN"
button to set the clock alarm on or off. When the clock alarm is set on, the display will show
the time on the left side. Press "UP" or "DOWN" button to set the time to wake you up.
Once the clock alarm is activated, press the start/standby button to mute the audible alarm.
(9) Clock
Press "MENU" button to select the [Clock XX:XX] menu, press "UP" or "DOWN" button to
set the current time.
(10) Turning off the Device
Remove the power cord from the electrical outlet, and disconnect power cord from the
power socket on the right side of the device.
NOTE: Once the setting is confirmed, press the “MENU” button. Otherwise, the device
will automatically go back to standby without saving the modification if no action
is taken in 20 seconds.
(11) Event Indication
While the device is on standby mode, press UP" and "DOWN" button at the same time to
see the latest one data of Apnea Index (AI), Hypopnea Index (HI) and Snoring Index (SI) on
the display. Press "MENU" button to show each index in sequence. To go back to standby
mode, press "START/STANDBY" button.
NOTE:
Once the device is re-started, all the indexes will be re-calculated. The whole
data of these indexes are only seen by respiratory therapists or physicians by
using Easy Compliance playback software.