Apogee Element Series Quick Start Guide | 19
Adjust how loudly you hear
the input signal by adjusting
the speaker or headhpone
output volume knob.
3. Raise the Gain knob as you input signal.
You will see input meter
move with this signal.
Continue
raising the
Gain knob
until this meter
gets close to
the top on your
loudest input.
If the Over
indicator is
triggered, the
Gain knob is
too high and
should be
lowered.
Note: Adjustments to the Mixer 1 faders only
aect monitoring and does not alter the signal
being sent to your recording program or DAW
To Next Page
Loading...
