Need help?Do you have a question about the Apogee Rosetta 200 and is the answer not in the manual?
General| Type | A/D and D/A Converter |
|---|---|
| Channels | 2 |
| A/D Conversion | 24-bit |
| D/A Conversion | 24-bit |
| Sample Rates | 44.1 kHz, 48 kHz, 88.2 kHz, 96 kHz, 176.4 kHz, 192 kHz |
| Bit Depth | 24-bit |
| Digital I/O | AES/EBU, S/PDIF |
| Clock I/O | Word Clock In/Out |
| Word Clock | Yes |
| Analog Inputs | 2 x XLR |
| Analog Outputs | 2 x XLR |
| Digital Inputs | AES/EBU, S/PDIF |
| Digital Outputs | AES/EBU, S/PDIF |
| Power Supply | External |
Details the AC input requirements and universal power compatibility of the unit.
Provides step-by-step instructions to get the Rosetta 200 operational quickly.
Describes how to select internal sample rates or lock to an external clock source.
Explains how to configure AES I/O for Single or Double wire operation at higher sample rates.
Details setting the optical output format between ADAT (S/MUX) and S/PDIF.
Lists and explains the various external clock sources the unit can sync to.
Describes setting the ratio between Word Clock input/output frequency and the unit's sample rate.
Selects the input source routed to all digital outputs, typically Analog for A/D conversion.
Details engaging Sample Rate Conversion for digital inputs or outputs to manage clocking.
Describes the analog process for rounding transient peaks to prevent digital overs.
Explains toggling AUTO SRC and setting digital output resolution (24-bit/16-bit).
Details how to enter and use CAL mode for A/D and D/A channel calibration.
Describes APTOMIZER for automatic A/D and D/A calibration and its LEARN/TRIM modes.
Selects the input source to be routed to the Analog outputs for D/A conversion.
Details engaging Sample Rate Conversion when a digital source is selected for analog outputs.
To Next Page
