Need help?Do you have a question about the Apogee Rosetta 800 and is the answer not in the manual?
General| Converter Type | A/D and D/A |
|---|---|
| Number of Channels | 8 |
| Sample Rates | 44.1kHz, 48kHz, 88.2kHz, 96kHz, 176.4kHz, 192kHz |
| A/D Conversion | 24-bit |
| D/A Conversion | 24-bit |
| Analog Inputs | 8 x XLR |
| Analog Outputs | 8 x XLR |
| Digital Inputs | AES/EBU, ADAT |
| Digital Outputs | AES/EBU, ADAT |
| Word Clock | In/Out |
| Dynamic Range | 117 dB D/A |
| Clock I/O | Word Clock In/Out |
| Power Supply | Internal |
| Dimensions | 19 x 1.75 inches (rackmount) |
| Weight | 12 lbs |
Statement regarding compliance with FCC rules for Class A digital devices and potential interference.
Legal notice protecting proprietary software and documentation against unauthorized copying or modification.
Statement of compliance with FCC rules for Class A digital devices, addressing interference.
Compliance statement for Canadian interference-causing equipment regulations.
Statement of conformity with European Union directives, including Low Voltage and EMC.
Statement of conformity with the VCCI Class A standard for Japan.
Statement of conformity with Australian AN/NZS standard requirements.
Visual representation of the device's signal paths and input/output routing.
Instructions for initial power connection and factory reset procedure.
Step-by-step guide for basic setup and initial configuration.
Details on the power switch operation and its configurable settings.
How to select and configure sample rates and advanced settings for AES I/O.
Configuration of sync source and word clock output frequency.
Explanation of the lock LEDs indicating clock synchronization precision.
Configuration of input sources routed to digital outputs, including advanced settings.
Enabling transient limiting and bit-reduction algorithm for digital outputs.
Understanding signal indicator LEDs and configuring analog output routing.
Details on DB-25 analog and Toslink ADAT/SMUX input/output connectors.
Information on AES/EBU, Word Clock, and AC power input connections.
Example setup for using Rosetta 800 as AD/DA converter for an AES digital device.
Example setup for converting ADAT input to AES and monitoring AES output.
Advanced setup for mixed analog/AES inputs to ADAT and monitoring ADAT output.
How to set calibration levels for analog inputs/outputs using internal jumpers.
Configuration of power switch behavior via internal jumpers.
To Next Page
