At the keel:
- Check the crossbar center plates assembly including the sweep wire/X-bar
junction and the center bolt.
- Also, visually inspect the crossbars by sighting along the length of the crossbars
looking for any evidence of damage.
- Check all bolts, nuts and the safety rings, which secure the downtubes to the
channel. Make sure that the channel and hang detail are secured.
- Check the universal joint bracket position and general condition.
- Fit the nose cone over the front of the keel and attach the Velcro at the top rear
of the nose cone. Pull the bottom corners of the nose cone back until the nose
cone is tight around the nose and secure the Velcro on the bottom of the nose
cone.
Now your wing is ready for mounting it onto the trike.
WARNING! Don’t fly without the nosecone!
6.6.2 Go around the trike and control the next items:
- Check the streamlining polyester cowling and its fastenings for possible damages. Pay
a special attention is to the position and fastenings of the sensors of the instruments
(Pito- and Ventouri tubes)
- Check the bolts, nuts and their securing on the nose tube.
- Check the condition of the wind screen and its fastening. Clean it if necessary
- Check the fork of the nose wheel, its mountings and the nose wheel. Check the
pressure of the tire by considering its flattening on the ground. Pump if necessary.
To Next Page
Loading...
Need help?
General
