EasyManua.ls Logo

Apollo CITY - Prepare for assembly; Unfolding; Attach handlebar

Apollo CITY
19 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
1
2
3
4
3
1
2
4
5
6 7
The first step is to unfold your
Apollo City. To do so, ensure
the hook is not clipped into the
rear foot rest. If it is, push down
on the stem and unhook it from
the rear foot rest.
Unfold the stem by pulling it to
a vertical position. Ensure you
do so until the stem is
completely vertical.
Locate the folding latch and
bring it up, locking the stem.
The latch will require some
force to lock fully upright.
Lastly, make sure the safety
button of the folding
mechanism is clipped in the
stem. This safety mechanism
prevents the latch from
unlocking due to vibration or
shock.
Remove the four hex screws from the handlebars
and connect the male connection cable coming
out of the handlebar into the female cable coming
out of the front stem. Make sure the pins are
aligned.
Make sure the male port and the female port are
aligned properly. Insert the handlebar at the top of
the front stem and tighten into place with the four
hex screws provided.
Caution: Be careful not to damage the cable when
connecting the handlebar to the front stem.
You will find that the latches and buttons on your
handlebar are not tight. We deliver this way to
avoid damage during shipping. Before tightening
the screws, adjust the left button panel. Twist it
upward or downward until it reaches a comfort-
able angle, keep in mind that once on a scooter,
you will be higher up than you are while setting up
your scooter. When you have found a comfortable
position, go ahead and tighten the screws.
Repeat the same process for the screws on the
right hand side of your handlebar.
Prepare for assembly
Unfolding
Attach handlebar
2
3
4
1
3
5
1 2
4
Always follow the below instructions when unfolding your scooter and prior to
each ride. Failure to ensure the safety button of the folding mechanism is clipped
into the scooter stem and to ensure the stem is fully secured before your ride
may lead to the stem coming undone during your ride, which can result in loss of
control, serious injuries and death. Do not operate the scooter if you notice
anything wrong with the scooter stem, the safety button, or the locking
mechanism.

Related product manuals