EasyManua.ls Logo

Apollo SL30 - Serial Interface Specifications; Interface Overview, Data Formats, and Messages

Apollo SL30
88 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Serial Interface Specifications
Apollo SL30 Installation Manual
59
APPENDIX E - SERIAL INTERFACE SPECIFICATIONS
This appendix includes the interface specifications for the RS-232 serial port. The RS-232
port can be used to input active and standby frequencies, and is used to input frequencies from
a remote source, such as the SL50/60 and 2001 GPS. The interface format conforms to
NMEA 0183 message format specifications.
INPUT COMMANDS
The following input command messages are supported:
• Input airport identifier associated with remote Comm frequency list
• Input Comm frequency data from a remote source
• Input VOR frequency data from a remote source
• End of VOR frequency list from a remote source
• Start of Localizer frequency list from a remote source
• Input Localizer frequency data from a remote source
• Request data output
• Set active VOR/LOC frequency data from a remote source
• Set standby VOR/LOC frequency data from a remote source
• Set standby COMM frequency data from remote source
• Set NAV audio mode
• Active COMM frequency
• Set Omni-Bearing Select (OBS) value from remote source
• DME sensor input
OUTPUT MESSAGES
SL30 output messages include:
• Reset status
• CDI, GSI, and flags
• Decoded OBS setting
• Radial from active VOR
• Radial from standby VOR
• Decoded station identifier
• Communications error
• NAV Receiver status
• NAV audio mode
• NAV microcontroller software version
• NAV DSP software version
• Comm transceiver status
• Comm software version
• ADC Data Output

Table of Contents

Related product manuals