34
Auxiliary DC jack(Cigarette
lighter)
The auxiliary DC jack is located at the
right side of the front panel.
The auxiliary DC jack can be used for
suitable work lights, radios, etc.
The auxiliary DC jack should only be
used when the engine is running.
1. Set the light switch to “OFF”.
2. Start the engine.
3. Pull out the cigarette lighter, and then
insert the accessory power plug into
the jack.
4. When the auxiliary DC jack is not
being used, put back the Cigarette
lighter.
Maximum rated capacity for the auxiliary
DC jack: DC 12V, 120W (10A)
CAUTION:
●Do not use accessories requiring
move than the above maximum
capacity. This may overload the
circuit and cause the fuse to blow.
●If accessories are used without
the engine running or with the
headlights turned on, the battery
will lose its charge and engine
starting may become difficult.
Cigarette lighter
Auxiliar
To Next Page
Loading...