90
Fuse replacement
The main fuse and the fuse boa are
located under the hood. If a fuse is
blown, turn off the main switch and
install a new fuse of the specified
amperage. If a fuse is blown, replace
it as follows.
1. Remove the battery compartment
cover by lifting it up and pulling it out.
2.Turn the key to “OFF” and turn off
the electrical circuit in question.
CAUTION:
To prevent accidental short- circuiting,
turn off the main switch when
checking or replacing a fuse.
3. Remove the blown fuse, and then
install a new fuse of the specified
amperage.
Troubleshooting
Although vehicles receive a rigid
inspection before shipment from the
factory, trouble may occur during
operation. Any problem in the fuel,
compression, or ignition systems can
cause poor starting and loss of power.
The troubleshooting chart describes a
quick, easy procedure for making
check. If your vehicle requires any
repair, take it to dealer.
The skilled technicians, at dealership
have the tools, experience, and
know-how to properly service your
vehicle. Use only genuine parts on
your vehicle. Imitation parts may look
like parts, but they are often inferior.
To Next Page
Loading...