GENERAL INFORMATION
1 -28
RSV mille
1.10.2 GENERAL SPECIFICATIONS OF THE DRIVING
TORQUES
The following table indicates the standard driving torques
for screws and bolts with metric ISO thread.
For specific joints or couplings of the vehicle, see 1.10.3
(DRIVING TORQUES).
If not specified otherwise, the indicated driving torques
are valid for clean and dry threads, at room temperature.
NOTE In order to avoid any deformation and/or imper-
fect coupling, tighten the screws or bolts by proceeding
as described below:
◆ Manually screw all the fastening elements.
◆ Applying half the prescribed driving torque, tighten the
elements that are diametrically opposite each other: (A)
and (B); (C) and (D).
◆ Repeat the previous operation by applying the pre-
scribed driving torque.
NOTE In this way the pressure exerted by the fasten-
ing elements will be uniformly distributed on the joint sur-
face.
For the maintenance intervals, see 2.1.1 (REGULAR
SERVICE INTERVALS CHART).
Screw or
bolt thread
Spanner
Driving torque
Nm kgm
M6 10 6 0.6
M8 12 15 1.5
M10 14 30 3.0
M12 17 55 5.5
M14 19 85 8.5
M16 22 130 13.0
Release 00/2002-10
- 00
To Next Page
Loading...
General
