To Next PageTo Next Page
Need help?Do you have a question about the APsystems DS3 Series and is the answer not in the manual?
General| Type | Microinverter |
|---|---|
| Input Voltage Range | 16-60V |
| Operating Temperature Range | -40°C to +65°C |
| Enclosure Rating | IP67 |
| AC Output Frequency | 50/60 Hz |
| Max. DC Input Voltage | 60V |
| Start-up Voltage | 16V |
| Cooling | Natural Convection |
| Protection Level | IP67 |
| Model | DS3 |
| Output Voltage | 240V |
| Communication | Zigbee |
| MPPT Voltage Range | 22-48V |
| CEC Weighted Efficiency | 97.0% |
| AC Output Power | 800W |
| Max. AC Output Power | 880 VA |
| AC Output Voltage Range | 220-240V |
Crucial safety instructions for installing and operating APsystems Microinverters.
FCC/IC compliance statement detailing potential radio frequency energy emissions.
Explains the meaning of various symbols used throughout the manual and on the device.
Explains how individual MPPTs in microinverters optimize energy harvest from each PV module.
Highlights the distributed nature of APsystems microinverters for enhanced system reliability.
Discusses the ease of installation for individual APsystems microinverters.
Details the ECU and EMA for monitoring system performance and receiving alerts.
Lists optional APsystems components required for installation.
Outlines the necessary parts and tools that the installer must provide.
Details requirements for PV Rapid Shut Down Equipment as per NEC standards.
Verifying grid voltage compatibility with the microinverter specifications.
Instructions for arranging and wiring the AC bus distribution.
Guidance on mounting APsystems microinverters onto the PV racking system.
Procedures for grounding the APsystems microinverter system.
Instructions for connecting the microinverter's AC connector to the AC bus cable.
Steps for installing the end cap on the AC bus cable for proper sealing.
Guide to connecting APsystems microinverters to the PV modules.
Instructions for filling out the APsystems installation map with serial numbers.
Explains LED status indicators and how errors are reported by the microinverters.
Description of the LED behavior during microinverter startup.
Details the meaning of different LED light patterns during operation.
Information on identifying and resolving Ground Fault Detector Interrupter (GFDI) errors.
Guidance for other faults reported to the ECU.
Specific steps to troubleshoot microinverters that are not operating correctly.
Information regarding the maintenance requirements for the system.
Detailed technical specifications for the APsystems DS3 Series Microinverters.
A sample wiring diagram for a single-phase APsystems microinverter setup.
