APT-1 – User’s Manual (EU) Rev. 2019-01 en for il 15
Step 4: Connect the power output connector (Figure 12-1) of the power
supply (Figure 12-4) to the APT-1 power input socket (Figure 12-
2) while ensuring correct position of connector groove opposite the
guide key of socket (Figure 12-3).
NOTE: The APT-1 must be used only with an original APT-1
Power Supply unit.
Step 5: Insert Footrest (Figure 13-1) in one of the four mounting holes (Fig-
ure 13-2) in each of the APT-1 crank arms. Installation or removal
requires only a straight push or pull while simultaneously pressing
on the release pin (Figure 13-3) as shown. Secure feet in place
with straps fastened diagonally as shown in Figure 10.
NOTE: The choice of mounting hole provides variable resistance
levels and ranges of motion. See operation instructions.
Step 6: Plug the power supply mains power plug into the electrical socket
outlet (Figure 10-3). The APT-1 will enter a stand by position. To
start operating, press the button. The green ACTIVE mode
indicator will light up. You may start exercising in the ACTIVE
mode. For operation instructions, see 5.1 & 5.2.
NOTE: If the APT-1 moves across the floor during leg exercises,
make sure anti-slip pads (Figure 10-4) are clean. If possible – use
the APT-1 on a carpet or rubber mat.
To Next Page
Loading...