APT-1 – User’s Manual (EU) Rev. 2019-01 en for il 26
SECTION C – SERVICE INFORMATION
12. GENERAL MAINTENANCE INSPECTIONS & STORAGE
The rugged design of the Active Passive Trainer and the use of selected,
modern materials ensure minimal requirements for care and maintenance.
The APT-1 can be lifted safely in its folded position by grasping on to the
centre of either of the legs of the base and carrying like a suitcase.
NOTE: Improper handling or neglect in the care of the Active Passive
Trainer may reduce or cancel the coverage of the manufacturer’s warranty.
12.1. Regular care
Inspect Power supply cables and plug for visible damages.
Check power-input connector for visible damage or insecure fas-
tening.
On a regular basis check that all screws and components are fas-
tened tightly.
Ensure that the anti-slip pads under the base are always kept
clean.
CAUTION: If any damage is detected – do not use APT-1. Please
contact your authorized dealer. Only authorized personnel may
carry out repairs.
12.2. Cleaning instructions
Disconnect Power Supply and wipe dry with clean cloth.
CAUTION: For safe disconnection of the APT-1 always take the
mains plug out of the wall socket before removing the connector
from the APT-1 power socket.
Take care not to allow water to enter the unit. Keep cables and
electric components away from water and humidity.
12.3. Storage
Store the APT-1 between –20 and +40 degrees C and between
10% and 80% humidity.
For storage in a confined space, fold the APT-1 unit by pulling the
angle release knob (Figure 1-2) and lowering it to the flat position.
Tighten the angle-securing knob (Figure 1-3) to prevent uninten-
tional unfolding.
To Next Page
Loading...