APT APT-1 User Manual

APT-1 – User’s Manual (EU) Rev. 2019-01 en for il 14
8. INSTALLATION FOR USE – LEG EXERCISE
Step 1: Position the APT-1 on the floor close to an electrical socket outlet
(Figure 10).
For the APT-1 Hi-Lo: loosen the height securing knob (Figure 1A-
7, pull the grey ring of the height release knob (Figure 1A-6) and
adjust the unit to the required height.
Step 2: Loosen the angle-securing knob (Figure 10-1) and adjust the APT-
1 to the required angle. To increase the angle, lift the body of the
APT-1, allow it to “click” into one of the operating positions and
retighten the securing knob. To decrease the angle, pull the angle
release knob (Figure 11), lower the body of the APT-1, allow it to
“click” into another operating position and tighten the securing
knob.
CAUTION: Make sure that the minimum distance between
crank arm and the floor surface is approximately 5 cm. / 2”
(Figure 10-2)
Step 3: Place a chair at the desired distance from the APT-1. If necessary,
attach the Securing straps (Figure 10-6) between the APT-1 base
rings (Figure 10-5) and the chair legs to prevent any change in
distance between the APT-1 and the chair during leg exercises.

APT APT-1 Specifications

General

Brand	APT
Model	APT-1
Category	Fitness Equipment
Language	English