-10-
* Rotate the red rotary ring of the DC input connector clockwise and then pull it out to remove the
battery case. Do not pull it out forcibly.
* When using dual battery power supply, install the battery in the battery slot corresponding to the
red/black lock key successively;When removing the battery, press the red/black lock button and
then pull out the battery one by one. Do not pull it out forcibly.
* Dual battery: Voltage 12~16.8V; Recommended ≥6.6A continuous discharge.
* V-mount batteries are available for purchase.
* Only use batteries that support the necessary continuous current discharge specifications
mentioned above. If non-compatible batteries are used, the batteries will enter a protection state
and the lighting fixture will not operate as intended.
* Do not use a battery with a specification of more than 21V. Using the wrong battery will cause
damage to the lamp.
* Press the V port seat button and pull out the V-Mount battery upward. Do not pull it out forcibly.
* Rotate the red rotary ring of the DC input connector clockwise and then pull it out to remove
the D-tap to DC Cable. Do not pull it out forcibly.
2) Dual battery power supply
3) V -Mount battery powered
To Next Page