Aqara Magic Switch S1E - Network Setup Procedure; Connecting to Wi-Fi and App

* Please make sure the device is connected to a 2.4GHz Wi-Fi
network;
* The Wi-Fi name or password contains unsupported special
characters, resulting in failure to connect to the
If the device addition fails, please confirm the following:
Please select the corresponding platform to scan the code
to access the network. If you have been connected to the
network before, you need to reset the device if you switch
to another platform to connect to the network. Aer
resetting the network according to the prompts, scan the
code to access the network.
5
Please connect the mobile phone as close to the device as
possible, and make sure that the mobile phone and the
device are on the same Wi-Fi network (2.4GHz).
6
Open the Aqara Home App, click the "+" in the upper right
corner of the homepage, select "Magic Switch S1E", and
follow the instructions of the App.
7
* If you use HomeKit to add devices, you need to scan the
HomeKit QR code on the screen or manually enter the setup
code to add according to the prompts on the screen of the
App and the device.
If the adding fails, please select Retry on the device and try
adding again on the App. For assistance please check:
www.aqara.com/support.
8