Need help?Do you have a question about the Aqara Water Leak Sensor and is the answer not in the manual?
General| Model | SJCGQ11LM |
|---|---|
| Wireless Protocol | Zigbee |
| Battery Type | CR2032 |
| Ingress Protection | IP67 |
| Battery Life | 2 years |
| Operating Humidity | 0 - 100%RH |
| Dimensions | 50 × 50 × 15 mm |
| Range | Up to 100m (open area) |
| Compatibility | Aqara Hub |
| Operating Temperature | -10°C to 55°C |
Aqara Water Leak Sensor detects water leak and flooding and monitors the status of water leak. When the water leak or flooding occurs, it sends an instant alert notification via app.
A hub is required. Aqara Hub is required for HomeKit compatibility. Product is for indoor use only.
Download Aqara Home app, install Aqara hub, and add the sensor via the app following on-screen instructions.
Single press the reset button to check if the hub confirms communication with the accessory.
Place the sensor directly on the surface where water leaks need to be monitored.
Use a hex screwdriver to loosen probes and connect cables for advanced smart scenes.
Open cover with coin, insert new CR2032 battery (positive side out), close and tighten cover securely.
Not a toy, for indoor use only, avoid heat sources, do not repair yourself, intended for home enhancement.
Risk of explosion if battery is replaced with an incorrect type.
Dispose used batteries properly. Do not ingest battery; it can cause severe internal burns. Keep away from children.
Suitable for mounting up to 2m height. Avoid fire, crushing, or extreme temperatures/pressure for disposal.
To Next Page
