Quartz bath with overflow filler installation instructions Page 10
Secure the controller onto the
back plate with the fixing screw
located at the base of the controller
using a small Posidriv screw driver.
12
Feed the control connection end of the
data cable through the centre hole in
the mounting template. Run a bead of
silicone sealant in the mastic groove on
the back of the mounting plate and
press into position onto the finished
wall surface. Ensure the data cable is
held securely by the narrow middle slot
of the mounting plate and fix to the
wall using the screws provided.
10
Plug the data cable into the rear of the
controller and push fully home. Slide the
controller assembly onto the mounting
plate.
11
Ensure the data cable is the correct way round as both ends differ in
type of connection used.
!
To Next Page
Loading...
