Quartz bath with overflow filler installation instructions Page 11
Connect the processor power lead to a
double pole 3amp switched fused spur,
incorporated in the wiring circuit, in
accordance with current wiring rules.
Ensure that this is located in an
accessible, dry location and not in the
bathroom.
14
Connect the outlet pipe to the mixed water outlet on the Digital
processor. Using pipe clips as appropriate, ensure that all pipe work is
perpendicular to the processor, i.e. not putting any strain on the
fittings.
13
TO ENSURE OPTIMUM PERFORMANCE USE THE MINIMUM AMOUNT
OF ELBOWS.
TO MAXIMISE FLOW RATES WE RECOMMEND USING COPPER PIPE
WITH THE MINIMUM AMOUNT OF ELBOWS.
BEFORE ANY ELECTRICAL ADJUSTMENT IS ATTEMPTED, THE
ELECTRICITY SUPPLY MUST BE TURNED OFF AT THE MAINS SWITCH.
ELECTRICAL INSTALLATION MAY ONLY BE CARRIED OUT BY
A QUALIFIED PERSON.
!
THIS APPLIANCE MUST BE EARTHED.
We recommend protecting surface mounted cables in suitable,
approved conduit to avoid the risk of damage from vermin.
The data cable and power lead should also be clipped in place with ‘P’
clips or similar, to avoid accidents.
!
To Next Page
Loading...
