Aqualisa QUARTZ DIGITAL SERIES - Page 9

Quartz bath with overflow filler installation instructions Page 9
Attach the supply pipes to the Digital
processor, ensuring that the cold and
hot feeds are fitted into the
appropriately marked inlets.
6
DO NOT SOLDER NEAR TO PLASTIC COMPONENTS.
!
Place the paper template on the wall
in the desired location for the bath
control and mark all fixing points and
the data cable entry point. Remove the
template and drill a Ø16mm hole
at the appropriate position for the data
cable.
8
The data cable should be run in conduit to allow for replacement if
required.
!
Drill and prepare the four wall fixings for the controller using the
fixings provided.
9
Run a pipe from the mixed water outlet on the Digital processor through
to the proposed siting for the bath fill outlet.
7
Suitable non restrictive double check valves (not supplied) MUST
be fitted to the blended outlet pipe in line with current Water
Supply Regulations.
!