Quartz™ Bath Installation Guide 17
USER GUIDE
The Quartz™ bath system has a maximum run time of 12 minutes as a
precaution to prevent overflow.
The bathfill can be stopped at anytime by pressing the ‘Start/Stop’ button.
Bath overflow filler user guide
1. Push the waste cover to engage the plug fitting.
2. Push the waste cover again to disengage the plug fitting.
Please do not leave the bath filler running unattended. Although the overflow
will remove excess water once the bath is overfilled, this may not be sucient
to prevent the bath from overflowing (depending on system conditions).
If you have any queries regarding the installation of this product please contact
the Aqualisa Customer Service Department on 01959 560010.
Bath controller user guide
1. Turn the temperature dial to the required setting.
2. Press the ‘Start/Stop’ button on the controller, to
fill the bath.
3. The blue LED display will flash until the selected temperature has
been reached and will then remain constant.
4. The temperature may be adjusted once the bath is filling.
5. Press the ‘Start/Stop’ button on the bath controller to stop the bath filling,
when at the desired depth.
To Next Page
Loading...
