14
STEP 5: Flushing and tesng the plumbing lines
WARNING! If the system is leaking at all, turn the unit to the bypass
position and shut off main water supply before assessing leak.
IMPORTANT: Flushing the system lines is necessary to ensure that all
plumbing work has been done correctly, that there is no debris or air
trapped in the piping, and that there are no leaks.
1. Locate the nearest faucet and remove aerator (faucet screen) if there is any.
Turn the cold water position on at the nearest faucet and slowly turn on the
main water supply. Let the water run for a few minutes or until the system is
free of any air or foreign material.
2. Make sure there are no leaks in the plumbing system before proceeding and
shut off the nearest faucet when water runs clear.
STEP 6: System Startup
1. Plug the AC adapter into a nearby wall outlet.
2. A LED indicator on the ballast should start to glow green indicating that the
lamp is turned on and the system is in operation.
WARNING! If the LED indicator on the ballast is not showing any color,
check the wall outlet to make sure it has power. Make sure to unplug the
power supply anytime if removal of UV lamp is required.
To Next Page
