Aquatic A2 - User Manual

— 1 —
Customer Service (800) 945-2726 • www.aquaticbath.com
Installation Instructions
4-Piece A
2
Composite Shower System Models
GENERAL INSTALLATION INFORMATION
Thank you for selecting Aquatic. To insure maximum performance from the Aquatic fixture, please read and follow the
instructions and cautions. Carefully inspect the new Aquatic fixture for any shipping damage. If such damage is found,
report it to your vendor immediately. Under no circumstances should a damaged Aquatic fixture be installed. Aquatic and it’s
Distributor are not responsible for removal or reinstallation costs if a replacement fixture is necessary due to installation of a
damaged fixture. Do not make modifications to the Aquatic fixture. This could adversely affect the safety and performance of
the Aquatic fixture and void the warranty. Any failure to comply with the installation instructions and cautions may void the
warranty. For questions concerning installation and maintenance of the Aquatic fixture, contact Technical Services at
1-800-945-2726.
3/16"
Drill Bit
Phillips Screw Bit
NOTE: Caulk is NOT
needed for this installation.
Tape
Measure
Safety Glasses
Hammer Level
#10 x 1 ½ self –tapping
washer head screw
OR 1 ½ Galvanized roofing nail
Hole saw
Drill
Tools Needed
Items Included
Tub/Shower Shower

Summary

Pre-Installation Planning

Review Job Prints and Rough-in Dimensions

Verify key dimensions against actual job conditions ensuring proper and square rough-in.

Locate and Add Studs for Nailing Surface

Ensure vertical nailing surface for fixture flanges by locating or adding studs.

Ensure Framing Pocket is Square and Level

Check framing pocket size, squareness, and levelness; shimming may be required.

Adhere to Local Codes

Observe all local plumbing and building codes for proper and safe installation.

Recommended Fasteners

Details on fasteners for wood, concrete, and steel studs, including pre-drilling.

Installation Procedure

Framing Dimensions and Checks

Place Base into Framing

Level and Secure Base

Installation Procedure Continued (1)

Install Right Side Wall Panel

Level and Shim Right Side Wall

Installation Procedure Continued (2)

Make Openings for Fixtures

Install Drain Assembly and Base

Final Leveling and Shimming of Unit

Fasten Base and Side Flanges

Install and Secure Back Wall Panel

Level and Shim Back Wall

Installation Procedure Continued (3)

Fasten Back Wall and Side Flanges

Install and Secure Right Side Wall

Check Level and Shim Right Side Wall

Fasten Top and Side Flanges of Right Wall

Installation Procedure Continued (4)

Install and Secure Left Side Wall

Fasten Top and Side Flanges of Left Wall

Clean-Up and Maintenance

Cleaning Precautions

Use only recommended cleaners; avoid abrasives, solvents, and specific chemicals.

User Maintenance Instructions

Guidelines for normal cleaning, polishing, and removing residues to maintain finish.

Aquatic A2 Specifications

General

Battery Life	Up to 4 hours
Camera Resolution	4K UHD
Model	A2
Type	Underwater Drone
Max Depth	100 meters (328 feet)