12 Aquatic
Infinity Owner's Manual & Installation Guide
OPERATION INSTRUCTIONS
NOTE: DO NOT START PUMP UNTIL ALL JETS ARE SUBMERGED. WATER LEVEL SHOULD BE 2” ABOVE HIGHEST JET.
BATHSIDE CONTROL SYSTEMS
KeyPad A Functions LED
1: ON/OFF PUMP
1st Press:The pump starts ON
2nd Press:The pump stops OFF
2: BLOWER & CYCLE
1st Press: Blower starts at high speed. ON
2nd Press: Wave Cycle - Speed goes gradually from maximum to minimum. BLINKS
3rd Press: Blower stops OFF
3: SEQUENCER MASSAGE MODE
1st Press: Massage Mode A Starts. ON
2nd Press: Massage Mode B Starts.
BLINKS TWICE
follows the speed of the valve
3rd Press: Massage Mode C Starts.
BLINKS 3 TIMES
follows the speed of the valve
4th Press: Massage Mode D Starts.
BLINKS 4 TIMES
follows the speed of the valve
5th Press: Massage Mode Stops. OFF
4: SPEED INCREASE
When the blower is on without the sequencer, press and hold to increase the blower speed. Release pres-
sure at the desired speed. When the sequencer is on, press to increase the speed at which the sequencer
operates. Release pressure at the desired speed.
ON
When Pressed
5: SPEED DECREASE
When the blower is on without the sequencer, press and hold to decrease the blower speed. Release
pressure at the desired speed. When the sequencer is on, press to decrease the speed at which the
sequencer operates. Release pressure at the desired speed.
ON
When Pressed
6: CHROMATHERAPY
1st Press: Turn on the light in white ON
2nd Press: Rainbow cycle – Low speed ON
3rd Press: Rainbow cycle – High speed ON
4th Press: Turquoise ON
5th Press: Blue ON
6th Press: Magenta ON
7th Press: Red ON
8th Press: Orange ON
9th Press: Yellow ON
10th Press: Green ON
11th Press: Turn off the light
Press and hold 2 sec. at anytime to turn off the chromatherapy
OFF
Advanced Programming
INTEGRATED 20 MINUTE AUTOMATIC TIMER
Integrated 20 minute automatic timer on the complete system. Count down starts with the last system turned on.
Blower LED will blink until the purge occurs except during the rst minute.
DRYING CYCLE
A 1 minute automatic drying cycle will start 20 minutes after the blower is turned off.
The blower LED button blinks while waiting for the purge cycle.
1: ON/OFF PUMP
2: BLOWER & CYCLE
3: SEQUENCER MASSAGE MODE
4: SPEED INCREASE
5: SPEED DECREASE
6: CHROMATHERAPY
A
BACKLITE KEYPAD
OR
To Next Page
Loading...
