18 Aquatic
Infinity Owner's Manual & Installation Guide
TUB CARE
MAINTENTANCE (CONT.)
Surface Cleaning
Use common household, non-abrasive cleaners for most cleaning jobs. Rinse well and dry with a clean cloth. Never use
abrasive cleaners. Do not allow your Lucite® acrylic surface to come into contact with products such as acetone (nail
polish remover), nail polish, dry cleaning solution, lacquer thinners, gasoline, pine oil, etc. Remove dust with a soft, dry
cloth. Clean grease, oil, paint, and ink stains with isopropyl (rubbing) alcohol.
Jet Cleaning:
All Infinity Series jets are removable, and can simply be put into the dishwasher for easy cleaning. See Jet Operation
Instructions for removal, pages 14-15. (Note: Use top rack of dishwasher and remove before the drying cycle starts.)
Surface Scratch Removal
Minor scratches may be removed by polishing your tub with a non-abrasive car polish, followed by buffing. Deeper
scratches can be removed by:
• Sanding with wet 400 grit sandpaper.
• Sanding with wet 600 grit sandpaper.
• Sanding with wet micro-grit sandpaper.
• Buff out using car polish.
REPAIR
The service of your whirlpool bath should be performed only by a qualified service technician. Remember when contacting
your dealer always have your serial number, proof of purchase and model number available. This will ensure a quick
response on warranty items.
The model and serial numbers are located above the pump on the backside of the whirlpool.
NOTE: ALL WARRANTY REPAIRS MUST BE AUTHORIZED BY AQUATIC BEFORE WORK IS STARTED. FOR SERVICE,
ALWAYS CONTACT YOUR DEALER.
CAUTION: Care should be taken to prevent inappropriate chemicals coming in contact with the Lucite® acrylic surface.
Please read and observe all instructions and/or warnings on containers containing substances you contemplate applying
to your whirlpool. Any failure to comply may void your warranty.
To Next Page
Loading...
