To Next Page
M
Mary BruceSep 12, 2025
Why is RPM readout inaccurate on ARAG IBX100 Control Unit?
- HHeidi YoungSep 12, 2025
If the RPM readout is inaccurate on your ARAG Control Unit, it might be due to a wrong setup. Check the rpm sensor constant setting.
Why is RPM readout inaccurate on ARAG IBX100 Control Unit?
If the RPM readout is inaccurate on your ARAG Control Unit, it might be due to a wrong setup. Check the rpm sensor constant setting.
How to fix imprecise speed on ARAG Control Unit?
If the displayed speed on your ARAG Control Unit is not precise, it is probably caused by a wrong setup. Check the setup of the wheel constant.
What to do if ARAG IBX100 output volume readout is inaccurate?
If the output volume readout is inaccurate on your ARAG Control Unit, it could be due to several setup issues. You should check the setup of the row width, the folwmeter constant, the wheel constant, and the section valve type. Also, verify the connections to the speed sensor.
Why is the instantaneous pressure readout inaccurate on my ARAG IBX100 Control Unit?
If the instantaneous pressure readout on your ARAG Control Unit is inaccurate, it could be due to a wrong full scale setup for the pressure sensor. Also, the pressure sensor might not be calibrated, so you should perform setting. Finally, check the connections to the pressure sensor to ensure it is correctly installed.
How to fix section valve controls that take no effect on ARAG Control Unit?
If the section valve controls on your ARAG Control Unit take no effect, it might be because the valves are not connected. Connect the IN-CAB cable and the connection cable to the valves.
What to do if sprayed fluid count displayed does not match liters/gpm actually sprayed on ARAG IBX100 Control Unit?
If the sprayed fluid count displayed on your ARAG Control Unit does not match the liters/gpm actually sprayed, check the following: * The flowmeter constant might be set up incorrectly: check the setup of the flowmeter constant. * The section valve type might be configured incorrectly: check the setup of the section valve type. * The counter may need to be reset: reset the counter. * If using three-way section valves without setting metered by-passes, perform the setting.
What to do if traveled distance count displayed does not match actual distance covered on ARAG IBX100 Control Unit?
If the traveled distance count displayed on your ARAG Control Unit does not match the actual distance covered, consider the following: * The wheel constant might be set up incorrectly: check the setup of the wheel constant. * There may be connection issues with the speed sensor: check the connections to the speed sensor. * The counter may not have been reset: reset the counter.
Why is the instantaneous pressure readout inaccurate on ARAG IBX100?
If the instantaneous pressure readout is inaccurate on your ARAG Control Unit, consider the following: * The full scale setup for the pressure sensor might be configured incorrectly: check the full scale setup for the pressure sensor. * The pressure sensor may not be calibrated: perform the setting. * The pressure sensor may be installed incorrectly: check the connections to the pressure sensor.
Why is the RPM value not displayed on my ARAG IBX100?
If the RPM value is not displayed on your ARAG Control Unit, it could be because the IBX100 does not receive signals from the RPM sensor or the RPM sensor is wrongly installed. Check connections to RPM sensor.
How to fix inaccurate RPM readout on ARAG IBX100 Control Unit?
If the RPM readout is inaccurate on your ARAG Control Unit, it is probably caused by a wrong setup. Check the RPM sensor constant setting.
General| Brand | ARAG |
|---|---|
| Model | IBX100 |
| Category | Control Unit |
| Language | English |
