What to do if instantaneous pressure is not displayed on ARAG IBX100?
If the instantaneous pressure is not displayed on your ARAG Control Unit, it could be caused by a wrong pressure sensor setting. Also, the IBX100 might not be receiving signals from the pressure sensor, or the pressure sensor might be wrongly installed. In both cases, check the connections to the pressure sensor.
Why does distance travelled count on ARAG IBX100 Control Unit not match actual distance?
If the distance travelled count displayed on your ARAG Control Unit does not match the actual distance covered, it could be caused by a wrong setup of the wheel constant or incorrect connections to the speed sensor. Ensure the counter has been reset.
What causes the sprayed fluid count to be incorrect on ARAG Control Unit?
If the sprayed fluid count displayed on your ARAG Control Unit doesn't match the actual liters/gpm sprayed, it could be due to a wrong setup of the folwmeter constant or the section valve type. Make sure the counter has been reset. If you're using three-way section valves, ensure metered by-passes are properly set by performing the setting.
How to troubleshoot ARAG IBX100 when covered area count is incorrect?
If the covered area count displayed on your ARAG Control Unit doesn't match the actual area covered, it could be due to a wrong setup of the row width or the wheel constant. Check the connections to the speed sensor. Also, the counter might not have been reset, so reset the counter.
Why is the instantaneous pressure readout inaccurate on my ARAG IBX100 Control Unit?
If the instantaneous pressure readout on your ARAG Control Unit is inaccurate, it could be due to a wrong full scale setup for the pressure sensor. Also, the pressure sensor might not be calibrated, so you should perform setting. Finally, check the connections to the pressure sensor to ensure it is correctly installed.
What to do if ARAG IBX100 output volume readout is inaccurate?
If the output volume readout is inaccurate on your ARAG Control Unit, it could be due to several setup issues. You should check the setup of the row width, the folwmeter constant, the wheel constant, and the section valve type. Also, verify the connections to the speed sensor.
How to fix imprecise speed on ARAG Control Unit?
If the displayed speed on your ARAG Control Unit is not precise, it is probably caused by a wrong setup. Check the setup of the wheel constant.
General| Brand | ARAG |
|---|---|
| Model | IBX100 |
| Category | Control Unit |
| Language | English |
To Next Page
