© 2020 Araknis Networks
®
12
Araknis Networks AN-210/310-SW-F/R Manual
Product Manual
Table of Contents
Rack Mounting Guidelines
Elevated Operating Ambient – If installed in a closed or multi-unit rack assembly, the operating ambient
temperature of the rack environment may be greater than room ambient. Therefore, consideration should be
given to installing the equipment in an environment compatible with the maximum ambient temperature of
104°F.
Reduced Air Flow – Installation of the equipment in a rack should be such that the amount of air flow
required for safe operation of the equipment is not compromised.
Mechanical Loading – Mounting of the equipment in the rack should be such that a hazardous condition is
not achieved due to uneven mechanical loading.
Circuit Overloading – Consideration should be given to the connection of the equipment to the supply circuit
and the eect that overloading of the circuits might have on over-current protection and supply wiring.
Appropriate consideration of equipment nameplate ratings should be used when addressing this concern.
Reliable Earthing – Reliable earthing of rack-mounted equipment should be maintained. Particular attention
should be given to supply connections other than direct connections to the branch circuit (e.g. use of power
strips).
Structured Wiring Can Mounting
(Example shown uses the AN-210-SW-C-8P for illustrative purposes.)
Note – The switch may only be mounted to the structured wiring can with the Ethernet ports facing
right or left.
To Next Page
Loading...
Need help?
General