If you have any queries regarding the installation of this product, please contact the distributor from whom it was purchased, or alternatively the ARB office in your state.
Head Office – ARB Corporation Ltd VIC: 42-44 Garden Street, Kilsyth, Victoria, 3137 Tel: (03) 9761 6622 Fax: (03) 9761 6807
WA:(08) 9244 3553 NSW: (02) 9821 3633 ACT: (02) 6280 7475 SA: (08) 8244 5001 QLD: (07) 3872 3872 NT: (08) 8947 2262 TAS: (03) 6331 4190
• If the latches do not operate
simultaneously, locate the black plastic
clips on each end of the pull rods to the
latches, unclip a pull rod, lengthen or
shorten it by winding it in/out and
re-clip in. Close the latches with your
fingers again and test operation via the
interior rear door handle to operate
simultaneously.
• Once satisfied, refit the door cover lower
portion with the scrivets, but ensure to
guide the pull rods into slits in the foam
blocks on the door cover at both ends.
If the latches can be seen to bind on
the door frame strikers, it may be
necessary to adjust the door frame
strikers.
Do this by the following:
• Place one thickness of masking tape
around the striker bar where the latches
contact. Open and close the door. If the
tape shown signs of wear through on the
top side or underneath of the striker bar,
it is necessary to adjust the striker away
from the side on which the wear is
shown. The aim is only to have wear
on the outward face of the striker bar.
• Undo the M6 screws slightly on the
strikers and adjust their position slightly.
Re-torque screws to 9Nm.
• Test the door again and adjust via the
above methods until satisfied.
To Next Page
Loading...
