Flex 8ES/EX Standard, AB and Tandem Instruction Manual (CE)
November 2016
Page 26 of 45
41 32 65 87
4132 65 87
4231 7856
41 2 3 65 78
4.2.2.9 Toggled Contact
When pushbutton is released the corresponding output relay will maintained contact
or closure until next time the user presses the same pushbutton again. This type of
relay action usually applies to external application such as lights. Refer to section
4.2.3.2 on how to set to this function.
4.2.2.10 Pitch & Catch Function
This function allows two operators controlling from opposite ends of a crane or
equipment. When set to “Pitch & Catch” make sure the 2
nd
transmitter is set to the
next upper channel (channel X+1). For example, if the system is set to channel 01
then the newly added 2
nd
transmitter must be set to channel 02 with identical serial
number. Furthermore, the Channel dipswitch position #7 and #8 on the decoder
board must set to “10” for 2-channel scanning (scans channel 01 and 02). Refer to
section 4.2.2.11 and 4.2.3.2 on how to set to this function. Pitch & Catch function
must set to assigned channel scheme (refer to section 4.1.2 part B).
4.2.2.11 Receiver Channel Scanning Function
Receiver channel scanning function is applicable only when a preset channel is
assigned to the system (refer to section 4.1.2 part B).
(1) → “00” manufacture preset (channel X)*
(2) → “01” scans 2 channels (channel X and channel X+1)
(3) → “10” scans 3 channels (channel X… channel X+2)
(4) → “11” scans 4 channels (channel X… channel X+3)**
* Channel X → channel set on the Channel dipswitch.
** Please contact ARC representative if your application requires scanning more
than 4 channels.
Example: If the first 6 dipswitch positions are set to channel 01 (000001), when set to 2-channel
scanning (type-2 above) the receiver will only scan channel 01 and 02.
To Next Page
Loading...
