Flex 8ES/EX Standard, AB and Tandem Instruction Manual (CE)
November 2016
Page 32 of 45
5. Receiver Installation
5.1 Output Relay Contact Diagrams
Flex 8ES (single speed model)
Flex 8EX (dual speed model)
* For 9~36VDC power supply, wire #1 corresponds to the negative charge (-) and wire #3 corresponds
to the positive charge (+), wire #2 is GROUND.
* If PB7 (or PB8) is set to A/B pushbutton select or A/B rotary switch select function (AB models), connect
output A to K13 relay (or K14) and output B to K15 relay (or K16). Refer to section 4.1.8.2 on how to
set to this function.
To Next Page
Loading...
