Flex 8ES/EX Standard, AB and Tandem Instruction Manual (CE)
November 2016
Page 3 of 45
Table of Contents
Page
1. Introduction 4
2. Radio Controlled Safety 5
3. General System Information
3.1 Transmitter
3.1.1 External Illustration 9
3.1.2 Internal Illustration 10
3.2 Receiver
3.2.1 External Illustration 11
3.2.2 Internal Illustration 12
4. Function Settings
4.1 Transmitter
4.1.1 Transmitter Firmware Version 13
4.1.2 Transmitter Channel Settings 13
4.1.3 Remote Pairing 15
4.1.4 Transmitter Start Function Settings 16
4.1.5 Transmitter Inactivity Timer Settings 16
4.1.6 Transmitter Output Power Settings 16
4.1.7 Infrared Programming 17
4.1.8 Pushbutton Function Settings 17
4.1.9 Transmitter Access Card (TAC) Settings 21
4.1.10 Display Frequency Band 22
4.1.11 Output Feedback Settings 22
4.1.12 Infrared Function Settings 22
4.1.13 Zero-G Sensor Settings 22
4.2 Receiver
4.2.1 Receiver Channel Settings 23
4.2.2 Output Relay Configurations 23
4.2.3 Dipswitch Settings 27
4.2.4 Jumper Settings 29
4.2.5 Voltage Settings 30
4.2.6 Indicator Light and Buzzer Installation 30
4.2.7 Other Function Output Relays Settings 30
4.2.8 System Channels Table 31
5. Receiver Installation
5.1 Output Relay Contact Diagrams 32
5.2 Pre-installation Precautions 33
5.3 Step-By-Step Installation 33
6. Operating Procedures
6.1 General Operation 36
6.2 Master/Master Tandem Operation (Tandem models) 37
6.3 Master/Slave Tandem Operation (Tandem models) 38
6.4 A/B Pushbutton Select Operation 40
6.5 A/B Rotary Select Operation (AB models) 40
6.6 Pitch & Catch Operation 40
6.7 Transmitter Access Card (TAC) Operation 40
6.8 Changing Batteries 41
6.9 Battery Charging 41
6.10 System Status Light Indications 42
7. General Specifications 44
8. EU Declaration of Conformity 45
To Next Page
Loading...
