10-34
SET-UP AND SAFE OPERATING PROCEDURES
89210000
SECTION 10:
ARCAIR CLIMBER V-A TRAVEL SYSTEM
GENERAL
The CLIMBER V-A travel system consists of a tractor and aluminum track available in three
lengths. The track is attached to the work by quick release magnetic clamps. The tractor
has flat, overhead, vertical and horizontal uses. The tractor carries most cutting, gouging and
welding equipment, including CAC-A, GMAW, GTAW, SAW, plasma and oxy-fuel.
Gears drive the tractor on a rack attached to the track. The tractor guide wheels are adjustable
for wear and width variations. The tractor has four wheels for better stability, rigidity and ease
of adjustment. This rigid design is well suited for heavier or overhanging loads.
SAFETY
CAUTION
Keep hands and clothing clear from Tractor guide wheels. A possible pinch point
exists.
WARNING
Protect equipment and operator from falls. When using the travel system in the
vertical, horizontal, and overhead positions, fabricate and use safety attachments
preventing harm or damage to the operator or equipment. Magnetic clamps can
break free due to vibration, shock, etc.
ArcairClimber V_A Travel System
To Next Page
Loading...