12-44
SET-UP AND SAFE OPERATING PROCEDURES
89210000
Problem Possible Cause Possible Remedy
Circuit breaker for the
tractor keeps tripping
Defective motor speed control Replace motor speed
control
Engagement of drive gear to
track too tight
Check/reset drive gear to
track properly
Debris edged in between the
track teeth
Remove any debris from
track
Defective motor Replace motor
Defective circuit breaker Check/replace circuit
breaker
Excessive load Reduce the load
Defective transformer (220
VAC model only)
Replace transformer
Tractor loose on the track
Track section is worn Reset adjustable wheel
legs (See Section Climber
Wheel Adjustment)
Replace track section
Adjustable wheel legs are
loose
Reset adjustable wheel
legs and re-lock
TITAN MACHINE CARRIAGE
Problem Possible Cause Possible Remedy
Carriage will not run with
switch in the “ON” position
Engagement lever is not
engaged
Place lever in engage
position
Absence of appropriate power Check power continuity
from source to tractor
Blown fuse Replace fuse
Break in the power cable Repair/replace power
cable
Defective power switch Replace switch
Defective motor Replace motor
Defective motor speed control Replace motor speed
control
Trouble Shooting Guide
To Next Page
Loading...