ARCAIR N6000 Automatic System - Climber V-A Tractor

SET-UP AND SAFE OPERATING PROCEDURES
11-43
89210000
CLIMBER V-A TRACTOR
Problem Possible Cause Possible Remedy
Tractor will not run with
switch in the “ON” position
Engagement lever is not
engaged
Place lever in engage
position
Absence of appropriate power Check power continuity
from source to tractor
Tripped breaker on the tractor Reset breaker
Break in the power cable Repair/replace power
cable
Defective power switch Replace switch
Defective motor Replace motor
Defective motor speed control Replace motor speed
control
Defective transformer (220
VAC model only)
Replace transformer
No power to the aux./
convenient outlet
Absence of appropriate power Check power continuity
from source to tractor
Tripped breaker on the tractor Reset breaker
Loose connection on the outlet Check connections on
the inside enclosure and
secure
Defective outlet Replace outlet
Tractor will not run with the
switch in the auto mode
Absence of voltage to
receptacle
Check/repair as required
Tripped breaker on the tractor Reset breaker
Defective power switch Replace switch
Defective motor Replace motor
Defective motor speed control Replace motor speed
control
Defective transformer (220
VAC model only)
Replace transformer
No control of travel speed
Loose set screw on
potentiometer
Tighten set screw
Defective potentiometer Replace potentiometer
Defective motor speed control Replace motor speed
control
Trouble Shooting Guide