ARCAIR N6000 Automatic System - Page 5

iii
GOUGING NON-FERROUS METALS ................................... 8-26
INSTALLATION STEPS FOR STRAIGHT POLARITY ............ 8-26
OPERATING THE N6000 SYSTEM ..................................... 8-27
J-GROOVE EDGE PREPARATION ....................................... 8-27
OSCILLATION GOUGING TO REMOVE
MATERIAL UP TO 4” WIDE ................................... 8-29
REMOVING FILLET WELDS AND OUT-OF-POSITION
U-GROOVE WELD PREPARATIONS ....................... 8-29
BACKGOUGING OF WEB TO FLANGE PLATES
ON FABRICATED GIRDERS .................................... 9-30
SECTION 9: ARCAIR TITAN MACHINE CARRIAGE ........................................ 9-31
GENERAL ........................................................................... 9-31
POWER .............................................................................. 9-31
CONTROL PANEL............................................................... 9-31
TITAN SETUP AND ASSEMBLY .......................................... 9-32
SECTION 10: ARCAIR CLIMBER V-A TRAVEL SYSTEM .............................. 10-34
SECTION 11: TROUBLE SHOOTING GUIDE ................................................. 11-38
N6000 Automatic System ................................................ 11-38
CLIMBER V-A TRACTOR .................................................. 11-43
TITAN MACHINE CARRIAGE ............................................ 12-44
SECTION 12: REPLACEMENT PARTS ......................................................... 12-46
N6000 CONTROLLER REPLACEMENT PARTS ................. 12-46
N6000 CONTACTOR REPLACEMENT PARTS ................... 12-46
CLIMBER V-A TRACTOR REPLACEMANT PARTS ............ 12-48
TITAN MACHINE CARRIAGE REPLACEMENT PARTS ...... 12-49