E-29
English
Audio
Audio DRC – Selects the Audio Dynamic
Range Control mode to ‘Off’, ‘On’. or ‘Auto’
Dynamic Range is the range between the
loudest sounds and the quietest ones. If
set to ‘On’ you can listen to a movie at a
lower volume without losing sound clarity.
< Off – No dynamic range compression
< On – Dynamic range compression
< Auto – DRC is selected by the source
material
Speaker Setting – sets the number of
speakers and the level, distance and size.
You can select:
< 2 Channels – L (Left), R (Right)
< 3 Channels – L (Left), C (Centre), R
(Right)
< 4 Channels – L (Left), R (Right), LS
(Left Surround), RS (Right Surround)
< 5 Channels – L (Left), R (Right), C
Centre), LS (Left Surround), RS (Right
Surround)
Please refer to the “speakers” on page E-15
for speaker naming and placement.
For each of the speaker configuration you
can set the following:
< Subwoofer presence (On or Off). If
the subwoofer presence is set to On,
then the following subwoofer settings
can be adjusted: level, distance and
crossover
< Size - Large (capable of full frequence
range reproduction) or Small (not
capable of full frequency range
reproduction at the low frequency
end). Note that most of the home
cinema speakers are small.
< Level - calibration settings for the
test noise signal level through the
loudspeakers and measured at the
listening position
< Distance - calibration settings for the
distances between the loudspeakers
and the listening position
< Crossover - set the frequency at which
the Solo starts to redirect bass signals
to the subwoofer
Prologic II
Dolby Pro Logic II decoding is designed to
produce five-channel output from two-
channel source material.
There are three different options available
for this setting: Off, Movie or Music. The
Movie and Music modes are intended
for use as their names suggest. Due to
the different recording methods used for
movies and music it is recommended that
the correct decoding mode for your source
material is used to obtain best results.
< Movie mode: This mode provide a
surround sound effect from a stereo
input.
< Music mode: This mode is similar
to the movie mode, but with less
emphasis on the surround channels,
in order to preserve the original stereo
image.
SACD Priority – Selects the SACD track
used. (Solo movie only). You can select:
< Multi-ch – Multi-channel track
< 2-ch – Stereo track
Subwoofer – Specify whether or not a
subwoofer is connected to the unit. If the
subwoofer presence is set to On, then
the following subwoofer settings can be
adjusted:
< Level - calibration settings for the
test noise signal level through the
loudspeakers and measured at the
listening position
< Crossover - set the frequency at which
the Solo starts to redirect bass signals
to the subwoofer
Settings Menu
Display
Display
TV System
TV System
[select option]
B C
B C
B
C
B
C
B
C
OK
E
D
Display
Resolution
Display
HDMI Colourspace
Resolution
[select option]
HDMI Colourspace
[select option]
E
D
E
D
Auto
YCbCr
YCbCr422
Full RGB
RGB
xvYCC
NTSC
PAL
Auto
Auto
4K2K
1080p
1080i
720p
480p/576p
480i/576i
Settings Menu
Audio
Audio
Subwoofer Out
Subwoofer Out
[select option]
B
C
OK
E
D
Off
On
Audio settings diagram applies to
Display settings diagram applies to
To Next Page
Loading...
