To Next Page
W
wtaylorAug 3, 2025
What to do if my Arcan XL35 Jacks unit will not lift load?
- AAngela PetersAug 3, 2025
If your Arcan Jacks unit isn't lifting, purge air from the hydraulic system by following the procedure under OPERATING INSTRUCTIONS.
What to do if my Arcan XL35 Jacks unit will not lift load?
If your Arcan Jacks unit isn't lifting, purge air from the hydraulic system by following the procedure under OPERATING INSTRUCTIONS.
What to do if Arcan Jacks unit will not sustain load?
If your Arcan Jacks unit will not sustain a load or feels spongy, purge air from the hydraulic system by following the procedure under OPERATING INSTRUCTIONS.
What to do if Arcan Jacks unit will not lift to full height?
If your Arcan Jacks unit isn't lifting to its full height, purge air from the hydraulic system by following the procedure under OPERATING INSTRUCTIONS. Also, check to be sure the oil level is not too high or too low.
What to do if Arcan Jacks unit will not lower completely?
If your Arcan Jacks unit will not lower completely, check the oil level and make sure it is not overfilled.
Visual inspection before each use, check for cracked welds, leaks, damaged, loose or missing parts. Remove damaged/worn jacks from service.
No alterations shall be made to the product due to potential hazards.
Use service jack for lifting only. Always support vehicle with jack stands.
Critical safety warnings including correct jack usage, load limits, surface requirements, and the importance of reading the manual.
Procedure to purge air from the hydraulic system by pumping the handle.
Steps for raising and lowering a load, including placing jack stands and safety precautions.
Keep hands or feet away from the jack's hinge mechanism.
Use quality hydraulic fluid. Fill to the level of the filler screw hole.
Lubricate moving joints, saddle post, handle socket, lift arm pivot shaft, linkages, and wheels/casters.
General| Model | XL35 |
|---|---|
| Category | Jacks |
| Material | Steel |
| Warranty | 1 Year |
| Capacity | 3.5 tons |
