arcelik 283720 EB - Installation; Appropriate location for installation; Installing the plastic wedges

8 /25EN
Refrigerator / User Manual
3 Installation
3.1. Appropriate location for installation
Contact an Authorized Service for the installation of the
product. In order to prepare the product for use, refer the
information in the user manual and ensure that electrical
installation and water installation are appropriate. If not,
call a qualified electrician and technician to have any
necessary arrangements carried out.
B
WARNING: Manufacturer shall not
be held liable for damages that may
arise from procedures carried out by
unauthorized persons.
B
WARNING: Product must not be plugged
in during installation. Otherwise, there is
the risk of death or serious injury!
A
WARNING: : If the door clearance of the
room where the product will be placed is
so tight to prevent passing of the product,
contact the authorised service provider.
• Placetheproductonalevelfloorsurfacetoprevent
jolts.
•Ifyouaregoingtousetheproductinacabin/furniture,
there must be a clearance of at least 2 cm between
the side walls and the cabin/furniture.
• Installtheproductatleast30cmawayfromheat
sources such as hobs, heater cores and stoves and at
least 5 cm away from electrical ovens.
•Productmustnotbesubjectedtodirectsunlightand
kept in humid places.
• Yourproductrequiresadequateaircirculationto
function efficiently. If the product will be placed in an
alcove, remember to leave at least 5 cm clearance
between the product and the ceiling, rear wall and the
side walls.
•Iftheproductwillbeplacedinanalcove,remember
to leave at least 5 cm clearance between the product
and the ceiling, rear wall and the side walls. Check
if the rear wall clearance protection component is
present at its location (if provided with the product). If
the component is not available, or if it is lost or fallen,
position the product so that at least 5 cm clearance
shall be left between the rear surface of the product
and the wall of the room. The clearance at the rear is
important for efficient operation of the product.
• In environments where the room temperature drops
below 10°C, the refrigerator will continue to run to
preserve the food in the freezer. However, fresh food
in the fridge compartment might freeze due to the
cold environment.
3.2. Installing the plastic wedges
Plastic wedges supplied with the product are used to
create the distance for the air circulation between the
product and the rear wall.
1. To install the wedges, remove the screws on the
product and use the screws supplied together with
the wedges.
2. Insert the 2 plastic wedges onto the rear ventilation
cover as illustrated in the figure.