50
To replace the brakelight bulb, use the following procedure.
1. Remove the two screws and remove the lens cover.
2. Push the bulb in and turn it counterclockwise.
3. Install the new bulb by turning it clockwise while pushing in.
4. Install the lens cover.
Fuse
The main (7 amp) fuse is located in a
fuse holder near the battery under the
seat.
NOTE: To replace the fuse, open
the holder and remove the fuse;
then install the new fuse. A spare
fuse is located within the holder.
If there is any type of electrical system
failure, always check the fuse first.
Storage
Compartment/Tools
A basic tool kit is provided with the
ATV. It is located under the seat.
Maintain the tool kit with the ATV at
all times.
CAUTION
When replacing the headlight bulb, be careful not to touch the
glass portion of the bulb. Grasp the new bulb with a clean cloth.
CAUTION
Tighten the lens cover screws only until they are snug.
CAUTION
Always replace a blown fuse with a fuse of the same type and
rating. If the new fuse blows after a short period of use, consult
an authorized Arctic Cat ATV dealer immediately.
To Next Page
Loading...
