52
Preparation After Storage
Taking the ATV out of storage and correctly preparing it will assure
many miles and hours of trouble-free riding. Arctic Cat recommends the
following procedure to prepare the ATV.
1. Clean the ATV thoroughly.
2. Clean the engine. Remove the cloth from the exhaust system.
3. Check all control wires and cables for signs of wear or fraying.
Replace if necessary.
4. Change the transmission lubricant.
5. Charge the battery; then install.
6. Connect the battery cables making sure to connect the positive
cable first.
7. Check the entire brake system (cables, shoes, etc.), all controls, and
brakelight; adjust or replace if necessary.
8. Check the tire pressure. Inflate to recommended pressure as neces-
sary.
9. Tighten all nuts, bolts, cap screws, and screws making sure all cali-
brated nuts, cap screws, and bolts are tightened to specifications.
10. Make sure the steering moves freely and does not bind.
11. Check the spark plug. Clean or replace as necessary.
To Next Page
Loading...
