Topside functions
WiFi (in.touch only)
For the WiFi menu to appear in the Settings menu your in.touch
module must be equipped with software version 11.00 or higher.
This menu allows you to connect your in.touch module to a WiFi
network or to change ts network.
For more details about other in.touch connection methods please
see the in.touch techbook. To connect your in.touch module to a
wireless network, use the Up/Down keys to go to the WiFi option
in the Settings menu and Light key to select it.
After a few seconds the available networks will appear on the
screen, as well as their signal strength.
Use the Up/Down keys to move through the list. Select your net-
work by pressing on Light key.
If the WiFi network is password protected enter it when
prompted.
• Use the arrow keys to choose your letters and
change the type of character (uppercase, lowercase,
number, symbol).
• Use Key 2 to move the curser forward
• Use Key 1 to backspace
• Use Light key to conm
If no password is required the in.touch will connect
automatically.
Once the in.touch module is connected to a WiFi network a check
mark in a green circle will appear in the WiFi menu, and the net-
work logo will change to green in Settings menu.
Note:
WiFi logo color in Settings menu corresponds to the in.touch con-
nection state.
Yellow = not connected
Green = connected to a network
Yellow with wait icon = connection attempt to a network
Red with wait icon = in.touch no longer detected
(in.touch must be reset before next connection attempt)
Owners Manual - Classic Series
4949
To Next Page
Loading...
Need help?
General
