Startup Programming
Water Temperature Regulation
In a regulation cycle, the system rst generates water ow
through the heater housing and the plumbing, in order to
ensure accurate water temperature readings as well as
avoiding heater activation in dry conditions.
After verifying pump activation and taking a water temper-
ature reading if required, the system automatically turns
the heater on to reach and maintain water temperature at
Set Point.
The “Heater” indicator lights up when the heater is
on. It ashes when there is a request for more heat
but the heater has not yet started.
Cooldown
While performing this task, the heater is not allowed to
turn on and its icon ashes.
Smart Winter Mode
Our Smart Winter Mode protects your system from the
cold by turning pumps on several times a day to prevent
water from freezing in pipes.
The “Smart Winter Mode” indicator lights up when
the Smart Winter Mode is on.
Light Key
Press Light Key to turn lights on. A second press turns lights o. A
built-in timer automatically turns light o after 2 hours, unless it has
been manually deactivated rst.
The “Light” indicator lights up when light is on
Up / Down Keys
Use Up or Down key to set desired water temperature. The tem-
perature setting will be displayed for 2 seconds to conrm your
new selection.
2 pump spas have a combined Up/Down Key. Hold the button to
increase the parameter and release the button to stop. Hold the
button again to decrease the parameter.
The “Set Point” icon indicates that the display shows the
desired temperature, NOT the current water temperature!
Program Menu
Press Light Key to turn lights on. A second press turns lights o.
The program menu is accessible by holding down the Light key for
5 seconds. In the program menu the following parameters can be
set: clock, lter or purge cycles, economy mode and temperature
units. While in the program menu, use the Up or Down key to
adjust the parameters and use the Light key to jump to the next
parameter. The changes will be saved after the conrmation of the
last parameter only. If there is no action taken for 10 seconds, the
system will exit the program menu without saving any changes.
Owners Manual - Core Series
6262
To Next Page
Loading...
Need help?
General
