Arctiko ULUF - Advanced Setting Configuration Guide; Probe Calibration Procedures; Temperature Limits Configuration; Hysteresis Configuration

Press “ENTER” to access
menu and then
Press “ENTER” to access
advanced settings
Press “ENTER” to type
password
Press “ENTER” to access
“Service”
There are no changeable
settings in the service menu,
only display of different time
and temperatures values
Press “ENTER” to access
“Password protection ON/
OFF device”
Press “ENTER” to access
“Set date/time”
Press “ENTER” to access
“Ambient temp. settings”
Press “ENTER” to access
“Calibration”
Automatic defrost is not
available for the ULUF range
Manual defrost is not
available for the ULUF range
Press “ENTER” to access
“Hysteresis”
Press “ENTER” to access
“Temp. range limits”
ATTENTION!
Do not change the
hysteresis setting without
contacting a service
representative
- Use to choose probe
- Press “ENTER” to access
- Use to change
setting for calibration
- Use to highlight
“save”
Press “ENTER” to save
ATTENTION!
Do not change the
temp. range limits without
contacting a service
representative
- Use to enable/
disable password
protection
- Use to highlight
“save”
- Press “ENTER” to save
- Use to move
between elds
- Use to change
date/time
- Use to highlight
“save”
Press “ENTER” to save
- Use to change
settings for ambient temp
- Use to highlight
“save”
Press “ENTER” to save
Factory settings for the
password is “0000”
Press to select the
desired setting menu
32 33
Advanced setting instructions