6. The following images are examples of the data/parameters.
- Data
- Parameters
40 41
Info
Logging data Number of log entries
Time Date and time for log entry
Temperature chamber Temperature measured by the main
probe
Alarms
Power failure Marked with “H” if occurred
High Temperature Marked with “H” if triggered
Low temperature Marked with “H” if triggered
Door open Marked with “H” if triggered
Probe failure Marked with “H” if triggered
Compressor alarm Marked with “H” if triggered
Manual defrost Marked with “H” if cycle is running
Auto defrost Marked with “H” if cycle is running
Measurements
tmp1 Temperature measured by 1st probe
tmp2 Temperature measured by 2nd
probe (if present)
tmp3 Temperature measured by 3rd probe
(if present)
Compressor1 temp Temperature of compressor 1
Compressor2 temp Temperature of compressor 2
(if present)
Room temp Ambient temperature
Evaporator temp Temperature of evaporator (Not
applicable for ULUF-models. )
Events
Door open “0” – door closed / “1” – door open
Door opening time Duration opening duretion in
seconds
Description of data points:
To Next Page